Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Ordering References
• Installation
• Quality Approval
• Other Information

Features & Benefits

• Tested to the requirements of BS476: Part 22:1987: clause(s) 6/7
• Tested on uninsulated and insulated glass types, including radiation glasses
• Accredited and approved under the CERTIFIRE Scheme TS25 - Fire Resistant Glass, Glazing Systems and Materials
• • Certifire Certificate No. CF5287

Installation

For more detailed insturcitons, see application guides under the "Data Sheets" tab further above.

1. Cut the aperture and ensure that the aperture is square cornered, remove any dust or debris from the aperture lining
2. Remove the liner from the packaging, cut the liner to the required length. Remove the release paper from the liner and apply to the cut aperture. Apply even pressure during application to activate the adhesive properties of the self-adhesive system
3. Having prepared the timber beads to the required dimensions, remove the glazing seal from its packaging. Peel the yellow release paper from the seal and apply to the face of the bead. The glazing cap should overlap the top of the timber bead
• The bead should be manufactured from hardwood with a minimum density of 610kg/m³ Ash and Beech are not permissible for use in 60 minute glazing
4. Mitre the beads to the correct length and push into the aperture to ensure a tight fit. Having now installed the beads, the beads can now be mechanically fixed into position. Using 50mm long screws (No.8) at 150mm centres
5. Working from the reverse, push the glass into the aperture, ensure that the glazing fin does not fold inward on itself. Repeat step 4 and ensure that all screws are securely fastened. Screws may be either exposed using screw cups or where aesthetic finishes are required screws maybe recessed and finished

Quality Approval

Pyroplex Ltd has a Quality Management System that meets the requirements of ISO 9001, and is independently verified by BSI Quality Assurance under Certificate No. FM10371. Copies of this approval are available on request.

Other Information

End user should ensure that the door has been previously tested and certificated to accept a glazed aperture, failure to observe this guidance may invalidate the test evidence or approval for the door set assembly.

For glass types and aperture sizes refer to the CERTIFIRE certificate of approval CF5287 - available from the "Data Sheets" tab further above.

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.