Tremco SF105 High Performance Acrylic Adhesive is a thixotropic water-borne floor covering adhesive. SF105 has been specially developed for linoleum and vinyl floor coverings, particularly the highly plasticised types. It is also approved for use with PVC backed carpets.

Benefits:

• Strong initial tack and permanent bond
• Non-flammable
• Good plasticiser migration resistance
• Approved by most major manufacturers
• Approved for practically all vinyl (PVC) floor coverings
• Excellent grab characteristics and high achievable coverage rates - up to 67m² per 15kg unit using a 1.5 x 5 mm notched trowel
• For detailed product and application information please see the Product Data Sheet

 Preparation:

• Site conditions must comply with British Standards CP 102, BS 8203, BS 5325 and supplementary specifications
• The surfaces must be sound, clean, dry and free from oil, grease, paint, excessive dust and other contaminants liable to impair adhesion.
• Concrete and sand/cement screeds must be completely free from laitance
• Direct to earth subfloors must incorporate an efficient damp-proof membrane
• Underfloor heating must have been fully commissioned as per manufacturer's instructions and must be switched off 48 hours before and during installation
• The heating should be switched on 48 hours after completion but then only gradually as per the commissioning schedule

Priming:

• Porous surfaces must be primed with Tremco CS150 Primer

Application:

• Stir the adhesive thoroughly before use.
• Spread evenly using a correctly notched trowel (1.5mm x 5mm) for vinyl floor coverings.
• Only spread sufficient quantity of adhesive which can be covered within the products open time (10 to 25 minutes dependent on conditions)
• Lay the floor covering into the semi-wet adhesive (absorbent surfaces only)
• Press firmly from the centre to exclude air and ensure overall contact.
• Roll immediately in both directions using a 68kg flooring roller
• A second rolling is recommended
• For surfaces of low absorbency, the “double drop” method can be adopted, i.e. place the pre-fitted floor covering into wet adhesive and firm in to ensure transference of adhesive to the back of the vinyl
• Roll back and allow the SF105 Adhesive, which is now coating both surfaces, to “tack up” before carefully placing back into position
• Roll with a 68 kg flooring roller in both directions

Technical Data:

Please contact Rawlins Paints Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for more information.