Osmo Wood Reviver Power Gel is highly recommended for refreshing greyed exterior wood such as wooden decking, timber cladding, garden furniture and similar surfaces.

Wood Reviver Power Gel is a non-drip product, and thus it is easy to apply – especially on vertical surfaces. The gel penetrates the wood deeply and removes grey patina. Afterwards by re-applying oils, the fresh warm colour tone of the wood is restored.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Notes & Tips

Features & Benefits

• Restores the natural characteristic of unweathered wood; the fresh, warm colour tone is visible again
• Quick and easy to use
• Odourless and biodegradable
• Easy to apply – especially on vertical surfaces
• Penetrates the wood deeply and removes grey patina
• Highly recommended for:
• Wooden decking
• Timber cladding
• Garden furniture
• and similar surfaces

Notes & Tips

• Protect metal (e.g. hinges) and plants against direct contact (e.g. cover ornamental and farm plants with a tarpaulin.)
• Dampen the surface with water first, and apply the gel generously with a brush. It may be possible to achieve immediate cleaning results.
• Test the surface with a scrubbing brush along the grain of the timber to check performance
• If necessary, leave to soak for 20 minutes and scrub with a hard bristle brush or scrubber
• Once cleaned, rinse with plenty of fresh water and allow to dry
• Avoid using a pressure / jet washer to rinse the wood as this may damage the wood and significantly increase it’s absorbency
• Wood Reviver is most effective when applied onto bare, untreated timber as certain treatments may block the revival process – always trial apply
• Protect sensitive surfaces such as: plants, metallic components ( eg aluminium), sensitive stones and renders
• After drying the wood may appear quite light in colour. The true, refreshed colour of the wood will be revealed following the application of an Osmo finishing oil
• Surface can be finished after 2 – 3 days in good drying conditions. The moisture content of the wood should be below 20%RM prior to application
• Depending on the extent of the greying, rinsing with water may be sufficient or a stiff brush may be necessary to scrub clean the surface. The process may need to be repeated for severe greying