Professional use only - from the 24th August 2023, adequate training is required before industrial or professional use of this product.

Should you require training, visit - https://www.safeusediisocyanates.eu/

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application Notes
• Limitations

Features & Benefits

• High durability and long service life
• High movement accommodation
• Cold applied — no heating equipment required
• Fuel, oil and hydraulic fluid resistance
• Jet blast resistant
• Retains its movement accommodation of 25% on butt joints throughout the extremes of temperature, it does not harden in cold weather nor become excessively soft, or pick up in hot conditions
• Complies to BS EN 14188-2:2004
• Complies to BS5212 Part1:1990 
• Fosroc Colpor 200PF is non-flammable
• Please refer to the Product Data Sheet for full details of:
  • Standards Compliance
  • Properties
  • Joint Preparation
  • Priming
  • Mixing
  • Application Instructions
  • Cleaning
  • Storage
  • Health and Safety

Application Notes

• In trafficked areas the maximum expansion joint width should not exceed 30 mm, wider joints are likely to suffer mechanical damage
• It is necessary to recess the level of the sealant 5 to 8 mm below the pavement surface, the depth is dependent on the season and temperature at the time of sealing. Additional protection for the joint aris can be provided by chamfering the top edge
• The width/depth ratio of the Colpor 200PF seal should be 1:1 to 1½ :1 subject to a minimum 10 mm depth of sealant (example, contraction joint: 15 mm wide x 13 mm depth; expansion joint: 25 mm wide x 20 mm depth)
• Joint preparation: After thorough cleaning the base of the joint should be tightly packed with a joint backing cord - Fosroc Expandafoam, which should be placed to ensure the correct joint profile is produced
• Priming: Concrete joint faces should be primed with Fosroc Primer 19 or Fosroc Primer P20

Please see the Product Data Sheet for detailed information.

Limitations

• For the sealing of industrial floor joints, higher modulus sealants such as Nitoseal MS300 or Nitoseal PU800 (see separate data sheets) are recommended
• Not compatible with bituminous materials
• Where Colpor 200PF could come into contact with pavement asphalt, please contact our Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for advice
• Service life may not exceed 3 years in hot climates, especially those with high humidity
• Do not apply when substrate temperature is 5°C and falling