Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application Notes
• Limitations

Features & Benefits

• Environmentally friendly protective coating suitable for application to new and existing structures
• Dekguard CP is a component of Fosroc’s Renderoc system of concrete reinstatement
• Water based
• Single component, ready for use
• Allows water vapour to escape from the structure
• Contributes to protection against carbon dioxide ingress - reduced carbonation
• Resistant to the effects of, and provides long-term protection against chloride ion ingress, sulfates and water
• Weatherproof and durable in all climatic conditions
• Dekguard CP is a low viscosity liquid which can be applied by brush, roller or spray
• Complies with EN 1504-2 - Surface protection products (impregnation)
• Reaction to fire: EN 13501-1 Euroclass B s1 d0
• Please refer to the Product Data Sheet for full details of:
  • Specification Clause
  • Standards Compliance
  • Properties
  • Preparation
  • Application
  • Cleaning
  • Storage
  • Health and Safety

Application Notes

• Where Dekguard CP is used as a primer for another Dekguard coating, apply one or two coats as required
• Where Dekguard CP is used as a self-finish, apply two coats

Please see the Product Data Sheet for detailed information.

Limitations

• The application of Dekguard CP should not commence if the temperature of the substrate is below +5°C and over +25°C
• Dekguard CP should not be applied in windy conditions where early-age dust adhesion may occur, or where rain is likely within 2 hours at +20°C or within +20 hours at +5°C (up to 80% RH)
• At low temperatures/high humidities, drying times will increase
• Dekguard CP should not be considered for areas subjected to mechanical abrasion, e.g. traffic and foot traffic, or areas subjected to ponded water
• Porous substrates may require further coats to obtain a uniform consistency of finish

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.