Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application
• Limitations

Features & Benefits

• For professional use only
• Two-component, cold cured vinyl ester/acrylic copolymer reinforced with glass flakes
• Excellent resistance to demineralised water and a range of solvent
• For use as a lining in immersed environments where superior resistance to chemical attack is required
• Suitable for most chemical environments within the pH range of 0 to 9
• Suited for aggressive atmospheric and spillage conditions
• Applicable in thick coats by standard heavy duty airless spray equipment
• Excellent service temperature

Application

• For new build, maintenance and repair
• Stir well before use. It is recommended to use fixed volumes/can size for multi-component products. Mixing ratio: Base 35919 : Curing agent 99410 (98 : 2 by volume)
• Applicable in thick coats by standard heavy duty airless spray equipment. Nozzle pressure: 275 bar [4000 psi] Nozzle orifice: 0.025-0.048"
• If brush or roller application is used, more coats will be necessary to achieve the specified dry film thickness
• Apply at 500-3000 microns DFT/WFT (650 recommended), theoretical coverage rate 0.3 - 2m²/L
• Hard dry in 6 hours, fully cured in 4 days @ 20°C
• To avoid condensation, apply on a clean and dry surface with a temperature that is at least 3°C above the dew point
• Surface temperature must be above 10°C during application and curing
• Material temperatures should be between 15°C and 25°C. Retarder 99190 should be added if temperatures exceed 25°C/77°F
• Optimal paint temperature for proper mixing, pumping and spraying is: 15-25°C

Limitations

• Spray data are indicative and subject to adjustment. Pressure is for a material temperature of 20°C
• If brush or roller application is used, more coats will be necessary to achieve the specified dry film thickness
• Depending on the application and curing conditions, some of the volatile reactants may evaporate. Furthermore, the curing process is accompanied by contraction. As a result, volume solids and spreading rate are in practice lower than stated