- There are no more items in your cart
- Shipping Calculated at checkout
-
Sub-Total (inc. VAT)
£0.00
Fosroc Proofex 3000 is a cold applied, flexible, waterproof, high performance Type A waterproofing barrier membrane for a range of waterproofing and radon barrier applications including basements and substructures.
- Provides a vapour, radon and waterproof membrane to water excluding structures and protects concrete from attack by aggressive ground salts
- Complies with EN 13707:2004 and EN 13969:2004, BRE 211, and independently certified performance, BBA certificate (No. 09/4663)
For situations where ground gas protection is required see Proofex 3000MR.
Quick Links - Click To Jump To Section:
Features & Benefits
- Cross-laminated HDPE film for protection against damage
- Incorporates a cross laminated HDPE carrier film with a polymer modified bitumen compound
- Dimensionally stable
- Combines toughness with flexibility for detailing around corners
- Self adhesive layer system makes installation quick, simple and reliable
- Resistant to ground water, soluble sulfates and chlorides
- Radon protection as defined by BRE report 211
- Waterproofing barrier membrane, as defined in BS8102:2009, ‘Protection Of Structures Against Water From The Ground’
- Please refer to the Product Data Sheet for full details of:
- Standards compliance
- Specification Clause
- Properties
- Application Instructions
- Storage
- Health and Safety
Application Notes
- All surfaces should be primed with Proofex Primer
- Angle and corner details: A 40mm fillet should be formed at all internal angles using Proofex LM or Renderoc Plug 20. Where possible, a 25mm chamfer should be provided to all external angles prior to application of the reinforcing strip. All internal and external angles should be reinforced with Proofex Detail Strip or a 300 mm wide strip of Proofex 3000
- Can be applied vertically or horizontally
- For deck waterproofing applications where the lapping arrangement results in a side lap detail / end lap detail interface apply a 10mm diameter bead of Nitoseal MB175 to seal the joint
- Penetrations e.g. pipe entries through the Proofex 3000 membrane require special attention to detail. Use of Proofex Top Hats is recommended and should be stuck to membrane using Proofex Total Tape and sealed to pipe with Nitoseal MS60
- Surfaces should be protected from damage by Proofex Protection Board
- Can also be covered with Proofex Sheetdrain to give both protection and a drainage layer
- Backfilling should be carried out as soon as possible after application, preferably the same day
- Roll size: 1m x 20m, thickness 1.5mm
- Roll area: 20m²
- Edge laps: 75mm minimum. End laps: 150mm minimum
Data sheet
- Manufacturer
- Fosroc
- For Use By
- Professional Use
- Single, Two or Three Pack
- Single
- Pack Size
- 1 m x 20 m roll
- Coverage
- Roll area: 20 m²
- Manufacturer
- Fosroc
- Usages
- Below Ground Waterproofing
- Product Usage Type
- Waterproof Membrane
- Product Range
- Proofex
Be the first to ask a question about this product!
IMPORTANT SHIPPING & DELIVERY INFORMATION
Fosroc Proofex 3000 is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT
Fosroc Nitoseal MS60
One part, low modulus sealant based on hybrid silyl modified polyether (“MS”) technology. Suitable for use for sealing joints in concrete, brickwork, blockwork, perimeter sealing around doors and windows, and non-trafficked floor joints. Applied to joints between 5mm and 35mm wide For joint widths exceeding 35mm, please contact Rawlins...
Fosroc Renderoc Plug 20
Fosroc Renderoc Plug 20 is a rapid setting cement-based, water-stopping mortar which is easy to apply to horizontal, vertical or overhead surfaces at a wide range of thicknesses, conforming to the requirements of BS EN 1504 Class R1. For the rapid patching and plugging of concrete segments, concrete and brick tunnel linings, sewage systems,...
Fosroc Proofex 3000MR
Fosroc Proofex 3000MR is a high performance, self-adhesive waterproofing barrier membrane for resisting methane, radon and carbon dioxide, and preventing water entering buildings, basements and below ground structures. Provides a vapour and waterproof membrane to water excluding structures and protects concrete from attack by aggressive...
Fosroc Proofex LM
Fosroc Proofex LM is a two component bituminous rubber emulsion with special hydraulically hardening fillers for waterproofing of underground structures and intricate details e.g. pipe entries, covings etc. Tested in accordance with DIN 18195, parts 4 to 6. General test certificate No. P-22 1356 8 96-1, MPA Dortmund. Ideal for use in...
Fosroc Proofex Accessories
Fosroc Proofex Accessories are a range of accessories for use when applying Proofex products as part of a Fosroc Proofex Waterproofing System. Range includes: Proofex Protection Board, Top Hat, Proofex LM Mesh and Proofex Engage Detail Strip Proofex Total Flashing Tape, Total Tape Please see below for detailed information and order...
Fosroc Proofex Primer
Fosroc Proofex Primer is a primer for use on concrete, masonry and steel prior to application of waterproofing membrane on basements and below ground structures. For use with Proofex products in the Fosroc range. Please see the Product Data Sheet for the relevant base product for application and mixing details for Proofex Primer.
Fosroc Nitoseal MB175
Fosroc Nitoseal MB175 (formerly Fosroc Plastiseal) is a flexible rubber-bitumen joint sealant with excellent slump resistance, which stiffens to form a firm seal after application. For sealing joints in flashings, guttering and sheet laps Ideal for sealing joints in flashings, guttering and sheet laps in waterproofing systems such as...