Mapefloor I 62 W is a two-component epoxy resin water dispersed formulation.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Recommendations & Limitations
• Application & Preparation

Features & Benefits

• Applied on cementitious substrates or as finish for epoxy systems and forms a seamless coating with an attractive finish both on flooring and wall
• Forms a strong film with a good resistance to abrasion, chemicals, inorganic acids and bases, and it is also dustproof
• Withstands light vehicles and pedestrian traffic and avoids the absorption of moderate amounts of liquid on the treated surface
• Possible to form seamless coatings suitable for cleanrooms in class ISO 5 airborne particle emissions according to ISO 14644-1 standards, class -6.5/<-9.7 VOC/SVOC emissions according to ISO 14644-8 standards and excellent resistance to attack from microbiological and moulds contamination according to ISO 846 standards
• Meets the requirements of ISO 8690 standards for Cs and Co contaminants
• Meets the requirements of EN 1504-9 (“Products and systems for the protection and repair of concrete structures: definitions, requirements, quality control and evaluation of conformity. General principles for the use of products and systems”), and the minimum requirements of EN 1504-2, coating (C) according to PI, MC, PR and IR principles (“Surface protection systems for concrete”)

Recommendations & Limitations

• Do not apply Mapecoat I 62 W on substrates with capillary rising damp (contact Rawlins Technical on 0113 2455450 (option 2) or send a message to [email protected])
• Do not dilute Mapecoat I 62 W with solvent
• Do not apply Mapecoat I 62 W on dusty or crumbling substrates
• Do not apply Mapecoat I 62 W on substrates with oil or grease stains or stains in general
• Only apply Mapecoat I 62 W on substrates prepared according to specification
• Do not mix partial quantities of the components to avoid mixing errors; the product may not harden correctly
• Do not expose the mixed product to sources of heat
• Coatings made from Mapecoat I 62 W may change colour or fade if exposed to sunlight but this has no effect on their performance characteristics
• The coating may also change colour if it comes in contact with aggressive chemicals. A change in colour, however, does not mean that it has been damaged by the chemical
• If rooms where the product is being applied need to be warmed up do not use heaters that burn hydrocarbons; the carbon dioxide and water vapour given off into the air will affect the shine on the finish and ruin its appearance. Use electric heaters only
• Remove aggressive chemicals as soon as possible after they come in contact with Mapecoat I 62 W
• Use suitable specific cleaning equipment and detergent to clean the coating, depending on the type of dirt or stain to be removed
• Protect the product from water for at least 24 hours after application
• Rooms must be well ventilated after application but make sure the film of resin is not exposed to direct currents of air; if it does not dry evenly, the final colour and the shininess of the hardened film may appear uneven and patchy
• The temperature of the substrate must be at least 3°C above the dew-point temperature

Application & Preparation

Please refer to the data sheets in the tab above for further information.