Mapefloor Decor 700 is a two-component epoxy water-based paste.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Recommendations & Limitations
• Application & Preparation

Features & Benefits

• Applied by straight trowel from 1.5 to 3 mm of thickness. Once hardened, the surfaces are characterized by excellent resistance to abrasion and high resistance to chemicals
• Thanks to the creamy consistency of the product, highly decorative surfaces may be created such as a spatula effect or mottled finish. A multitude of different tones may also be obtained by adding to the product the specific pigment paste Mapecolor Paste, while preparing the mix
• Resin systems made using Mapefloor Decor 700 must always be protected with a polyurethane top-coat from the Mapefloor Finish range of product
• Choose the most suitable finishing product according to the degree of glossiness/mattness desired or the wear- resistance required
• Please refer to Mapei or Rawlins Technical Services for information (0113 2455450 (option 2) or send a message to [email protected])
• Mapefloor Decor 700 complies with the principles defined in EN 13813 “Screed material and floor screeds - Screed material - Properties and requirements” which sets out the requirements for screed material to be used for indoor flooring

Recommendations & Limitations

• Do not dilute Mapefloor Decor 700 with solvents
• Do not apply Mapefloor Decor 700 on dusty or crumbling substrates
• Do not apply Mapefloor Decor 700 on substrates with oil or grease stains or dirt in general
• Do not apply Mapefloor Decor 700 on substrates, which have not been previously primed with Primer SN and have not been suitably prepared
• Do not mix partial quantities of the components to avoid mixing errors; the product may not harden correctly
• Do not expose the mixed product to sources of heat
• Mapefloor Decor 700 systems change colour if exposed to sunlight, but this has absolutely no effect on their performance characteristics
• The colour can also change in case of contact with aggressive chemicals; a change in colour, however, does not mean that the resin system has been damaged by the chemical
• If rooms where the product is being used need to be warmed up, do not use heaters that burn hydrocarbons, otherwise the carbon dioxide and water vapour given off into the air will affect the shine on the finish and ruin its appearance. Use electric heaters only
• When possible, remove aggressive chemicals as soon as possible if they come into contact with Mapefloor Decor 700
• Use suitable specific cleaning equipment and detergent to clean the surfaces, depending on the type of dirt or stain to be removed
• Protect the coating from water for at least 24 hours after application
• The product cannot be applied directly on cementitious substrates with a moisture content higher than 4% and/or with capillary rising damp (carry out polythene sheet test)
• The temperature of the substrate must be at least 3°C higher than the dew-point temperature

Application & Preparation

Please refer to the data sheets in the tab above for further information.