Resin Technologies Degreaser is a preparatory and maintenance product which when diluted in water offers a powerful solution to clean and remove grease, stains and other contaminants from concrete and coated floors. The solution is slightly yellow in colour.

Supplied in 5 Litre single part units. Each pack will have variable coverage based on the level of dilution. Coverage will also vary depending on the porosity of the surface if applied to bare concrete.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Surface Preparation
• Application
• Health & Safety

Features & Benefits

• Powerful solution to remove grease, stains and other contaminants
• For use on concrete and coated floors
• Can be diluted for the following applications (see guide below):
  
  • Light cleaning for pre-prepared floors
  • General floor cleaning/preparation
  • Heavy grease, oil and petrol removal on bare concrete
• Apply via a cloth, brush or spray

Surface Preparation

• Resin Technologies Degreaser can itself be used as a preparation product to be used when preparing a floor for further coating
• It will handily remove grease and oil contamination as well as dirt and stains from concrete flooring
• It can also be used on already cured epoxy resin coatings for the same effect
  • It is advised to dilute to the 'general cleaning' strength (see below) so as to not damage your coating

Application

Pour Resin Technologies Degreaser into a suitable receptacle. To apply this product, you will need to dilute with water (hot water if possible). Different dilutions will produce different efficacy in cleaning, see the guide below for more details.

 Dilution ratio guide:

• Heavy grease, oil and petrol removal on bare concrete: Dilute 1:50 with water (100ml per 5L)
• General floor cleaning/preparation: Dilute 1:100 with water (50ml per 5L)
• Light cleaning for pre-prepared floors: Dilute 1:250 with water (20ml per 5L)

Once diluted, simply apply by your choice of cloth, brush or spray. Allow the solution adequate contact time on the surface for a few minutes and agitate it where necessary. Once applied and the dirt has been lifted by the solution, rinse the floor with clean water to remove any trace chemicals that might cause damage if allowed to rest for too long.

Approximate Coverage:

• Approximately 4-5m² per 1L of diluted solution when using the 'Heavy' dilution ratio above
  • Please note this is just a guide and is dependent on the porosity of the surface

For more information please see the Data Sheets in the 'Data Sheets' tab, or please contact our Technical Department on 0113 2455450 (option 2) or send a message to [email protected]

Health & Safety

• Wear appropriate PPE. I.E Gloves and protective safety goggles
• If in contact with skin wash off immediately with plenty of water. If discomfort occurs seek medical advice
• This product should be applied strictly in accordance with manufacturer’s instructions
• Please see the Safety Data Sheet before use