Resin Technologies All In One Repair Mortar is supplied in 10kg and 25kg pack sizes. Each unit is split between PART A, PART B and PART C. Weight measurements are for the whole unit.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Typical Properties
• Curing
• Mixing
• Surface Preparation
• Application
• Limitations
• Health & Safety

Features & Benefits

• Patch material for repairing concrete
• Heavy Duty
• Long-life durability
• Excellent adhesion & sealing qualities
• Surface Usable in 24 hours
• Impervious and Dust Free
• Heavy Duty and Suitable for High Traffic

Typical Properties

Curing

Mixing

• Mix using a slow-speed 1200w+ electric paddle mixer
• Mix Part A on its own for 2 minutes until homogenous
• Add Part B and mix for a further 2 minutes
• Slowly add Part C and mix together for 3 minutes
• Mixing too fast will cause trapped air in the mixture, avoid this where possible
• Adding all of Part C immediately will result in a sandcastle-like consistency
• For a wetter mix, do not add all of Part C
• Once activated, all product must be applied within the pot life of the product: 30 minutes at 20°C

Surface Preparation

• The damaged concrete surface should be a minimum of 28 days old
• Ensure it is free of laitance, dust, grease, oil or existing coatings
• Wire brushing is generally sufficient for this
• A tack coat may be used to prime the area if there is an excess of loose material - please contact our Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for details
• The Relative Humidity of the base should be 75% or lower

Application

• The mixed unit of Resin Technologies All-In-One Repair Mortar must be applied immediately
• Ensure the area has been cordoned off for safety purposes and to prevent the area being walked on whilst the product is curing
• Apply only in dry conditions at temperatures between 5°C and 25°C
• Follow the mixing instructions provided
• Once mixed, trowel the product evenly across the surface
• Be sure to compact the material with the trowel whilst applying
• For a perfect, smooth finish regularly wipe the trowel with a cloth dampened with white spirit as you apply
• The formula may be applied at 5-50mm thickness and can be feather edged at 5mm
• Once applied protect from weather and leave to cure
• Please note the pot life for this product is 30 minutes, the product will be unworkable due to chemical curing after this time, ensure you remove the paint from the tin during this window
• The product will be workable on your floor for 40 minutes
• For more information please see the Data Sheets in the 'Data Sheets' tab, or please contact our Technical Department on 0113 2455450 (option 2) or send a message to [email protected]

Limitations

• Do not apply on New or Wet Concrete (under 28 days with residual moisture content of or higher 6%)
• Do not apply at temperatures below 5°C
• Do not expose to Freezing Conditions
• Temperatures below 20°C will negatively impact curing/drying times
• Do not expose to chemicals, wash or allow water to rest on surface until 7 days after application
• This product is not UV Stable and may discolour if used in a location that experiences high amounts of sunlight

Health & Safety

• Wear appropriate PPE. I.E Gloves and protective safety goggles
• If in contact with skin wash off immediately with plenty of soap and water. If discomfort occurs seek medical advice
• This product should be applied strictly in accordance with manufacturer’s instructions
• Always refer to the Material Safety Data Sheet before handling or mixing this product