Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Directions
• Storage
• Limitations

Features & Benefits

• For Professional use
• Drying time of 2 minutes under normal conditions
• Fully cured in 24 hours
• Provides a permanent bond with good temperature resistance
• Can be removed with most solvent cleaners
• Clear liquid appearance
• Do not use on flexible PVC or expanded polystyrene

Directions

• Use in a well ventilated area
• Ensure all surfaces are clean, sound, dry and free from dust, grease or other contaminants
• Substrates should be conditioned before assembly, this is particularly important with laminates
• Condition for 48 hours at 20°C with a relative humidity of 45‐55% ‐ air should be able to circulate freely around all components
• Hold the aerosol at approximately 70° to the surface and apply a generous and even coat of adhesive, ensuring 80‐100% coverage, moving the aerosol parallel to the surface, pay particular attention to the edges
• On porous surfaces a second coat might be necessary – always apply to laminate first and spray one surface horizontally and the other vertically
• When the adhesive is dry to the touch, and does not transfer, it is ready for bonding
• Bring the two surfaces together and apply a uniform pressure, starting in the middle and working out, pay particular attention to the edges
• Drying time is 2 minutes under normal conditions, but this will vary with differing temperatures and humidities
• High humidity & low temperatures will slow drying time, and it the temperature gets very low it can produce bloom. Full cure takes 24 hours
• Avoid over spraying and pooling of the adhesive as this will increase the drying time and may cause adhesive to show through the laminate
• If the surfaces are bonded without allowing the adhesive to become dry, solvent entrapment will occur and this will lead to bond failure
• It is the user’s responsibility to dispose of all packaging correctly

Storage

• Store between 5° and 25° in clean dry shaded conditions in original unopened containers
• Do not allow the product to freeze
• Shelf Life: 12 months when stored as directed

Limitations

• Always test a small sample of the materials first to ensure the suitability of the product for the application
• For instance, some vinyls contain large amounts of plasticiser which, over time, can migrate and soften the bond
• When in doubt, test first
• Do not use on flexible PVC or expanded polystyrene
• It is the user’s responsibility to ensure suitability for use
• It is advisable to read the SDS prior to use
• Read the label carefully for essential health and safety information prior to use