Professional use only - from the 24th August 2023, adequate training is required before industrial or professional use of this product.

Should you require training, visit - https://www.safeusediisocyanates.eu/

Quick Links - Click To Jump To Section:

   
• Recommendations
• Application Procedure
• Storage and Safety Instructions

Recommendations

• Do not use Ultrabond P-R9 for external applications
• Do not use at temperatures lower than +10°C
• Before use, the product should be fully aclimatised in the area where it is to be applied
• After use, make sure the canister is well sealed
• Once opened, the product must be used as soon as possible
• If too much time passes between the first time the product is used and the second time, it may harden due to the amount of air in the canister

Application Procedure

Preparation of the Substrate:

• Drill a 2-3 mm diameter hole in correspondence with the ends of the parquet flooring to be repaired
• In the case of painted or pre-finished parquet, protect the area to be repaired and the joints in the flooring using masking tape, then drill the 2 mm hole

Preparation of the product:

• Ultrabond P-R9 is ready to use
• Cut off the tip of the nozzle so that it matches the drilled hole
• The upper part of the tip may be used again to seal the nozzle

Application of the product:

• Inject 2-3 drops of water into the hole, and after a couple of minutes, 1-2ml of Ultrabond P-R9
• Use the product at temperatures above +10°C
• The resin expands during the hardening phase
• Therefore, we recommend applying weights on the area treated to avoid the parquet flooring still to be repaired from moving
• Do not inject too much product into the hole
• After hardening, remove any excess product which seeps from the holes using a blade
• In the case of rough or polished floors, grout the hole with Ultracoat AquaPlus or Ultracoat Binder mixed with sawdust
• When repairing pre-finished or pre-varnished parquet, touchup or seal the hole with a suitably-coloured wax stick

Cleaning:

• Residues of Ultrabond P-R9 must be removed from pre-finished and varnished floors while still fresh using a suitable cleaning product
• Tools must be cleaned using a specialist cleaning product
• Once hardened, the product must be cleaned off by mechanical means, taking care to avoid damaging the surface of the parquet

Storage and Safety Instructions

• Ultrabond P-R9 remains stable for at least 12 months under normal environmental conditions in its original, sealed packaging
• Irritates the eyes, the skin and the respiratory tract
• Frequent contact with the skin may cause an allergic reaction in those sensitive to isocyanates
• It may also cause irreversible damage if used for long periods
• The product may become hazardous and cause sensitisation if inhaled at temperatures above +60°C
• In the event of sickness seek medical attention
• When applying the product, we recommended using protective clothing, gloves, safety goggles, a safety mask to protect the respiratory system
• Make sure all areas are well ventilated during application
• If the product comes into contact with the eyes or skin, wash immediately with plenty of water and seek medical attention
• For further information about the safe use of the product please refer to the latest version of the Safety Data Sheet (see 'Data Sheets' section above)