- There are no more items in your cart
- Shipping Calculated at checkout
-
Sub-Total (inc. VAT)
£0.00
Applied to concrete surfaces prior to the installation of a Visqueen cavity membrane system to prevent the leaching of free lime from the concrete substrate.
- An anti-lime sealer for concrete - reduces risk of cavity membrane system furring up
- Rapid application - can be applied by brush, roller or spray
- Concentrated formulation diluted on site - reduces plastic packaging
Visqueen CM Anti-Lime Sealer is a white liquid supplied as a 2 litre concentrate which when diluted with maximum 18 litres of clean water provides a ready to use 20 litre solution. The product dries clear.
Leaching of free lime, which then solidifies, causes blockages within the cavity membrane system. This prevents the free movement of water behind the membrane, ultimately stopping the water from reaching a gravity drain or a sump and pump system.
Blockages caused by free lime will increase the regularity of maintenance of a cavity membrane system and its pumps, or in some cases, cause the system to fail.
The sealer is used on concrete substrates including floors, walls, columns and kickers. It's also used on underpinned properties on either side of joints and dry-packed areas after an application of a cement-based tanking product.
Quick Links - Click To Jump To Section:
- Approvals and Standards
- Storage and Handling
- Preparation
- Installation
- Usable Temperature Range
- Additional Information
Approvals and Standards
- Quality Management System ISO 9001:2015
Storage and Handling
Visqueen CM Anti-Lime Sealer should be stored upright, undercover and in its original packaging. Store at temperatures between 5ºC and 35ºC.
To avoid the risk of spillage, always store and transport in a secure upright position. The unopened product has a minimum shelf life of 12 months.
Keep the container closed when not in use.
Care should be taken when handling the product in line with current manual handling regulations.
Preparation
Visqueen CM Anti-Lime Sealer is a white liquid supplied as a 2 litre concentrate which when diluted in a clean container or sprayer with maximum 18 litres of clean water, provides a ready to use 20 litre solution. Mix thoroughly before use. NB. Smaller quantities of sealer can be made up using the same ratio i.e. 1 part concentrate to 9 parts clean water.
New concrete must be at least 7 days old before the sealer solution is applied.
If there is any exposed steel present, apply two coats of suitable corrosion inhibitor to the exposed steel by brush.
Remove, by suitable means, all loose material and surface laitance, dust, oil, grease, corrosion and organic growth, preferably by using wet grit, water blasting techniques or equivalent methods.
Ensure there is no water pooling prior to application. The sealer solution can be applied to damp surfaces but not wet surfaces.
Installation
Apply a single coat of the sealer solution (see above dilution ratio) using a brush, roller or coarse sprayer. Ensure a complete and even coverage is achieved.
The substrate should be left for a minimum of 3 hours to allow the sealer solution to absorb. Once the substrate is touch dry it may be walked on or covered.
Usable Temperature Range
It is recommended that Visqueen CM Anti-Lime Sealer should not be applied at temperatures below 5°C.
Additional Information
Do not apply Visqueen CM Anti-Lime Sealer to areas previously treated with curing or sealing agents, unless these coatings have been removed by chemical or mechanical means.
Data sheet
- For Use By
- Consumer Use
- Interior / Exterior Use
- Interior Use
- For Use On
- Concrete Floors
Concrete Walls
Concrete Columns
Concrete Kickers - Min. Application Temperature
- 5°C
- Size
- 2L
- Suitable For Use On
- Retaining Walls
- Suitable For Use On
- Basement Walls
- Suitable For Use On
- Basement Floors
- Suitable For Use On
- Tunnel Walls
- Suitable For Use On
- Vaulted Ceilings
- Suitable For Use On
- Heritage Buildings
- Usages
- Waterproofing
- Product Usage Type
- Cavity Membrane
Questions
Question about the product
Be the first to ask a question about this product!
IMPORTANT SHIPPING & DELIVERY INFORMATION
Visqueen CM Anti-Lime Sealer is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT