AdSeal Imprinted Concrete Sealer is a colourless, non-yellowing, UV stable single component, low viscosity product with fast cure enabling rapid installation and early re-use of facility.

Increased impact and abrasion resistance maintains, and arguably increases, performance life of surfaces and can yield significant ‘whole life’ cost savings. Its unique formulation makes it easy to apply and achieve an even, uniform, and seamless finish.

Virtually eliminates grass and weed growth in any joints and reduces routine maintenance. A major feature is the combination of its hard wearing qualities with its ease of recoating/refreshing during future maintenance, unlike urethane based products.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application

Features & Benefits

• Single component - spreads easily, cures quickly for rapid re-use of facility
• Superior moisture resistance aids year round use
• Higher strength & better chemical resistance than traditional sealers
• Stops oil & other stains & incorporates a UV filter
• Improved impact & abrasion resistance prolongs performance life reducing whole life cost
• Reduces and eases routine maintenance
• Ease of future refurbing without the need to strip
• Excellent resistance to rain spotting, tyre plucks, etc
• Stabilises sand joints minimising weed & moss infestation

Not suitable for: Engineering bricks, highly polished & glazed surfaces.

Performance (low to medium trafficked areas): With correct maintenance and depending upon surface type, potentially 10 years plus*. Externally colour will remain for 1 – 2 years although protective effect will remain for longer, potentially 4 – 6 years, depending upon surface type.

*A major design feature of this product is that it is easily re-coatable and does not need stripping before future treatment as maintenance coats cross link into original forming a monolithic layer. Recoating worn areas effectively means that the sealer may never need stripping and replacing.

Application

• For use with:
  • AdSeal Colour Pigment (if required)
  • AdSeal Low-Slip Additive (recommended)
• Use as supplied without thinning down
• Surfaces should be clean, dry & free from oil, grease, dust, laitance and any other deleterious materials
• Do not apply in temperatures below +5°C or above +25°C and should not be subjected to extremes of temperature until completely dry
• It is important to undertake a representative test area to ensure that the product is suitable for your requirements prior to commencement of the project and assessed for final appearance, chemical resistance and wet and dry slip resistance. This is particularly important where the surface has previously been sealed
• Application should ideally be by an airless sprayer designed for solvent based products such as the AdSeal Compact Sprayer but application by brush or roller is also suitable [see detailed installation instructions]
• During application care should be taken to protect adjacent areas & equipment from overspray
• The surface should be sectioned off to assist accurate coverage
• On average apply at a rate of approximately 4m² per litre for your first coat and 7m² per litre for the second. Exact consumption will depend on age and porosity of the surface
• Apply in THIN uniform coats maintaining a wet edge but do not allow to puddle
• Under normal conditions it will be touch dry within 1 - 2 hours and may be lightly trafficked after 24 hours
• The above is to be read in conjunction with the detailed Installation Instructions Sheet and the current Safety Data Sheet available to download from DATA SHEETS tab above

Maintenance:

• Sweep regularly to remove abrasive dirt and grit from surface and rinse down weekly using a mild detergent if required
• Spills and marks should be wiped up as soon as possible and not allowed to dry on
• Heavy stains can be removed using AdSeal Surface Cleaner
• Should signs of wear appear a maintenance coat can be applied. Clean and thoroughly dry surface to be treated. Apply single ‘tight' coat which will cross link into earlier coats, so there is no need to strip unless there is resin build up or blemishes are an issue