• Up to 6-7 days depending on temperature, thickness of coating
• The product may remain slightly soft for a further period depending on climatic conditions, this is not detrimental to the waterproofing qualities of the product

Preparation

Dirt build up, moss and loose material should be removed by scraping or brushing. In cold conditions any ice present on the surface must be removed.

• Most roofing substrates to be treated will not normally require priming
• Application Temperature should be between 5°C-25°C

Highly Porous/Friable Surfaces:

• Concrete, Concrete and Asbestos Cladding, Sheeting and Guttering should be primed with Britannia Aquashield Primer (see separate technical sheet) prior to over coating with Britannia Aquashield Smooth Waterproof Roof Coating
• These Surfaces must be jet washed prior to applying the Britannia Aquashield Primer
• Fibrous cement, corrugated cladding, sheeting and guttering: other than repairs, we recommend the use of Durashield for this application

Metal Surfaces:

• Ferrous-new, weathered and previously painted galvanised iron and steel
• All these areas should be suitably prepared and primed as appropriate (see separate technical sheet) before application of Britannia Aquashield Smooth Waterproof Roof Coating

Non-Porous Substrates:

• Slate, Polished bricks should be power washed abraded and completely dry, free from any contamination to achieve adhesion of the Britannia Aquashield Smooth Waterproof Roof Coating

Bitumen Surfaces:

• Discolouration may occur over a new asphalt, tar or bitumen surface; therefore an extra coat may be required, for decorative purposes only
• Aged bitumen can be liable to crack, therefore further advice must be taken

Previously Painted Or Coated Substrates:

• It is good practice to inspect and carry out adhesion tests on any existing coating or substrate prior to application of the coating

Splits, Cracks, Joints and Seals, Crazed Areas:

• Pay particular attention to clean out any splits/cracks/joints and seals by scraping or brushing off with a stiff bristle brush before applying the Britannia Aquashield Primer
• Repair all faults in the surface by either Britannia’s Reinforcing Scrim in the first of two coats or using a proprietary sealer

Surface Faults:

• Repair all faults in the surface with either Britannia’s Reinforcing Scrim in the first of two coats or using a proprietary filler

In areas where excessive movement may occur, additional reinforcement must be incorporated into the coating.

Application

• To the dry and cleaned surface, apply a generous coat of Britannia Aquashield Smooth Waterproof Roof Coating by brush, roller or squeegee, at the minimum specified spreading rate as stated above under the heading
• Please follow the coverage rates shown in Spreading Rate Section
• Application Temperature should be between 5°C-25°C

Cleaning

• For cleaning equipment use Special Solvent (Not White Spirit)

Shelf Life & Storage

• Up to 2 years if stored correctly in an unopened container

Precautions

• Flammable keep away from sources of ignition
• Ensure good ventilation during application
• Over occupied premises during insulation of coatings we would advise keeping windows closed
• Wear gloves, goggles and suitable protective clothing
• In case of contact with eyes rinse immediately with plenty of water and seek medical advice
• Remove splashes from the skin with a recognised hand cleaner or plenty of soap and water
• Keep out of reach of children
• Do not use near fishponds
• Toxic to aquatic organisms
• May cause long term adverse effects in the aquatic environments
• Do not empty into drains