Professional use only - from the 24th August 2023, adequate training is required before industrial or professional use of this product.

Should you require training, visit - https://www.safeusediisocyanates.eu/

Carboline Polyclad 777 Slow-Set is a two-component, solvent-free aromatic polyurethane, ASTM D16 Type V. A high performance 100% solids structural polyurethane coating designed to provide superior corrosion protection for steel, ductile iron, and concrete pipe. Tenacious adhesion and high impact resistance allow its use in the harshest environments.

It forms a dense, long-term impermeable barrier that is ready for service moments after application through a snap-set cure mechanism. Typical uses include steel pipeline exteriors, steel valves and fittings, steel pilings, steel poles (above and below ground), buried tank exteriors, penstocks. No primer is required.

Available in fast, medium, and slow set times.

Click To Jump To Section:

• Features and Benefits
• Product Specification
• Drying Times
• Surface Preparation
• Application Methods
• Application Conditions
• Health and Safety

Features and Benefits

• Fast curing increases throughput
• Excellent abrasion resistance
• Touch dry in up to 7 minutes at 24°C
• Superior wetting properties for outstanding adhesion
• Mix ratio 1:1 and user-friendly application properties
• Can be topcoated by Carbothane series of products
• Unlimited build with single multi-pass coats
• Compliant with AWWA C222
• Compliant with EN 10290

Product Specification

• *Adhesion over 3,000 psi is common with high peak count, surface cleanliness and good adhesive. Preferred adhesives for running adhesion testing are 3M CA-100 and 3M DP-460

Drying Times

• Lower metal temperatures will slow the dry time and higher metal temperatures will speed up dry time
• Product is ready for holiday testing as soon as it reaches its dry-to-handle state
• Maximum recoat time with Carbothane series is 28 days
• To topcoat past the maximum recoat time, the surface must be abraded and cleaned
• Maximum recoat with itself is two hours

Surface Preparation

Application Methods

Application Conditions

• Industry standards are for substrate temperatures to be 3°C above the dew point
• Caution: this product in the liquid stage is moisture sensitive and needs to be protected from high humidity, dew, and direct moisture contact until cured to a firm state. Application and/or curing in humidity above maximum, or exposure to moisture from rain or dew may result in a loss of gloss, micro bubbling and/or blistering of the product
• Note: for applications on concrete, please contact your Rawlins on Tech - 0113 2455450 (option 2) or [email protected] for proper application procedures

Health and Safety

Clean Up

• Use Thinner 2 or Thinner 76
• In case of spillage, absorb and dispose of in accordance with local applicable regulations

Safety

• Observe the precautionary notices on the container label, and read the safety data sheet before use
• Employ normal workmanlike safety precautions
• Use adequate ventilation
• Keep container closed when not in use

Caution

• This product contains flammable solvents
• Keep away from sparks and open flames
• All electrical equipment and installations should be made and grounded in accordance with regulations
• In areas where explosion hazards exist, workers should be required to use non-ferrous tools and wear conductive and non-sparking shoes

• Refer to the product data sheet and safety data sheets in the attachments section above for further details