Use Magpaint Europe Beamer Paint For Pros to transform smooth interior surfaces, providing a sharp picture and rich contrast for beamer projection. Ideal for presentations and business environments.

The two-part paint consists of a primer and finish that can be applied to large and unusual surfaces to optimise for projection and is ideal for individual formats and curved walls. It is architectonically sophisticated, as the projection surface is integrated in the wall.

Beamer Paint can also be applied outdoors provided that the fresh layers of paint are not exposed to weather influences, wind and sunlight. BeamerPaint does not degrade or yellow under the influence of UV radiation.

Features

• Optimises walls for projection
• Ideal for large, unusual, and curved walls
• 2-part system (primer and finish)
• Can be applied with a roller or spray
• Compatible with Magnet Paint (check datasheet for requirements)
• Meets health and safety requirements for professional indoor use
• Contains minimum volatile organic compounds (VOC)

Usage

Before the projector paint can be applied, the surface must be stable (weight bearing), dry and clean. The subsurface must comply with the requirements set for gypsum substrates (level 4), or at least with a comparable classification.

Application

Apply BeamerPaint Base and Finish as a spray or with a Velour paint roller - it is essential to use clean tools. Clean used tools with water.

Base:

The substrate must be clean, dry, grease-free and stable. See ÖNORM B 3430-1. Substrates must at least meet the requirements for quality level Q4 for plaster substrates. All other surfaces must be prepared in accordance with this quality level.

Do not process at a temperature below +8°C and /or when the relative humidity exceeds 80%.

Apply two layers of BeamerPaint Base with 5-6 hours in between.

Allow the BeamerPaint Base to dry for 5-6 hours before starting to apply BeamerPaint Finish.

Finish:

Apply two layers of BeamerPaint Finish undiluted with 5-6 hours in between.

After applying the entire paint system, the surface should not be sanded to avoid ruining the look.

BeamerPaint is ready for use as soon as the last layer of BeamerPaint Finish is dry.

Coverage

BeamerPaint Base:

Approx. 5 m²/l. per layer, depending on a number of factors, such as porosity and roughness of the substrate and material loss while applying.

BeamerPaint Finish:

Approx. 10 m²/l. per layer, depending on a number of factors, such as porosity and roughness of the substrate and material loss while applying. With one packaging of 2 litres of Base and 1 litre of Finish, a 5 m² surface can be treated.

Drying Times

Base:

Finish: