Follow us on:

HMG Roadline Paint

HMG Roadline Paint

TOPROA
HMG4383

  • Fast drying paint for application to all types of road surfaces including bitumen (tarmac) types.
  • Based on a unique resin binder system.
  • Available in white and yellow.
Colour
Size
Finish
£99.46(incl. VAT)
£82.88(ex. VAT)
Quantity
Please choose your colour
Available for Delivery (See Delivery Options Below)

No queries yet, leave the first!
Description

HMG Roadline Paint is a fast drying paint for application to all types of road surfaces including bitumen (tarmac) types, based on a unique resin binder system.



Click To Jump To Section:




Features & Benefits


  • Based on a unique resin binder system
  • Available in white and yellow

The substrate temperature should be 5ºC or above for application and during cure, and a minimum of 3 ºC above the dew point.

Ensure adequate ventilation. Available in White (A274) and Yellow (A268)



Product Specification


Technical Data
Volume Solids: 77.2%
VOC Content: 0.400kgs/ltr
SG: -
Viscosity: -
Density: 1.599 g/cm³
Storage Conditions: Store between 5°C - 25°C. When not in use, cans must be kept sealed.
Shelf Life: 12 months from delivery date in original sealed containers.
Flash Point: 13°C



Film Thickness Range And Coverage


Product Data
  Dry Film Thickness Wet Film Thickness
Brush: n/a n/a
Roller: n/a n/a



Coverage: 12 square metres per litre @ 25 microns dft (Theoretical)

  • HMG technical data sheets indicate a dry film thickness that will be achieved when applying a particular wet film thickness.
  • These values are a guide only and are not to be used as specifications.
  • Film thickness will vary depending on actual use and specification.
  • Great care should be taken to achieve the dft stated in the agreed specification and to avoid areas of excessively low or high thickness.



Drying Times


Drying Times At 20°C
Touch Dry: 30 minutes
Fully Cured: 2 hours



Surface Preparation


  • Only simple preparation is required. Sweep surface to remove excess dust, dirt and loose material.
  • If surface is contaminated with oil or grease, remove completely using hot wash and degreasant.



Application Methods


Technical Data
Brush Roller
Mixing Ratio: Ready for use Ready for use
- -
Thinner Options: Thinner 2671 Thinner 2671
- -
Viscosity: - -
Spray Gun Setup: - -
Number Of Coats (Guide Only): 1 Coat 1 Coat
Flash Off: - -



For further information on mixing ratios please contact Rawlins Paints on Tech - 0113 2455450 (option 2) or [email protected] Sales - 0113 2455450 or [email protected]



Product Notes


Information on basic physical and chemical properties
Form: Liquid
Colour: According to product specification
Odour: Characteristic
Odour Threshold: Not determined
pH-value: Not determined
Change in Condition
Melting point/freezing point: Undetermined
Initial boiling point and boiling range: 78°C
Flash Point: 13°C
Flammability (solid, gas): Not applicable
Ignition temperature: 425°C
Decomposition temperature: Not determined.
Auto-ignition temperature: Product is not selfigniting
Explosive properties: "Product is not explosive. However, formation of explosive air vapour mixtures are possible."
Explosion limits: Lower: 3.5 Vol %
Explosion limits: Upper: 15.0 Vol %
Vapour pressure at 20°C: 59 hPa
Density at 20°C: 1.599 g/cm³
Relative density: Not determined
Vapour density: Not determined
Evaporation rate: Not determined
Solubility in / Miscibility with water: NOT MISCIBLE
Partition coefficient: n-octanol/water: Not determined
Viscosity: Dynamic at 20°C: Not determined
Viscosity: Kinematic: Not determined
Solvent content: Organic solvents: 21.1%
Solids content: 77.2%



Health & Safety


  • Refer to the safety data sheet in the attachments section above and tin label prior to use.

Click to go back to the top of the page

Product Details
4383-636624

Data sheet

Manufacturer
HMG Paints Limited
For Use By
Professional Use
Interior / Exterior Use
Exterior Use
Single, Two or Three Pack
Single
Mixing Ratio
RFU
Suitable Substrates
Tarmac
Touch Dry (at 20°C)
30 Minutes
Fully Cured (at 20°C)
4 Hours
Recommended Thinner/Cleaner
Thinner 2671
Density
1.599 g/cm³
Solids by Volume
77.2 %
VOC
0.400kgs/ltr
Shelf Life (from date of manufacture)
12 months from delivery date in original sealed containers.
Finish
Matt
Size
5L
UN Number
1263
Suitable For Use On
Concrete
Suitable For Use On
Tarmac
Suitable For Use On
Asphalt
Suitable For Use On
Bituminous Surfaces
Finish
Matt
Application Method
Brush
Application Method
Roller
Product Usage Type
Topcoat
Colour Family
Yellow
Colour Family
White
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.

Questions

Question about the product

* Required fields
(read)

Be the first to ask a question about this product!

IMPORTANT SHIPPING & DELIVERY INFORMATION

HMG Roadline Paint is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.

Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.

Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.

All delivery costs below are excluding VAT


You might also like