RSL Tyre Mark Remover is a specialised heavy duty cleaner designed to remove particularly stubborn rubber deposits such as tyre marks from floor surfaces. Safe to use on epoxy and polyurethane coatings and screeds, RSL Tyre Mark Remover is water rinsable and leaves no slippery residues.

Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application Rates & Methods
• Typical Physical Characteristics
• Storage and Handling
• Disposal
• Health and Safety

Features & Benefits

• Specialised heavy duty cleaner
• Designed to remove particularly stubborn rubber deposits, such as tyre marks, from floor surfaces
• Safe to use on epoxy and polyurethane coatings and screeds
• Water rinsable
• Leaves no slippery residues
• Supplied ready to use

Application Rates & Methods

Supplied ready to use.

Manual

Sweep floor to remove debris. Apply product to the area to be cleaned with a spray, cloth or mop. Leave for a few minutes and wipe off. If mark does not lift immediately, apply a little more product and leave for 10 to 20 minutes. Clean floor area thoroughly with a 2% solution of R.S. Industrial Floor Cleaner.

Floor Cleaning Machines/Scrubber Driers

Sweep floor to remove debris. Apply product to the area to be cleaned with a hand held spray or back pack system. Leave for a few minutes. Attach red pads or stiff brushes to a combination scrubber/dryer machine. Charge with a 2% solution of R.S. Industrial Floor Cleaner. Make the first pass of the scrubber drier machine without using the vacuum, giving the product additional contact time with the floor. On the second pass, scrub floor and recover soiling as usual.

Estimated Coverage

100ml to 200ml of product should clear an area of approximately 1m² . This is dependant on the level of soiling and more stubborn deposits may require more R.S. Tyre Mark Remover to completely remove them.

Typical Physical Characteristics

Storage and Handling

Shelf Life (unopened containers) : 12 Months

Protect against frost. Where product has been stored in cold temperatures, leave to reach ambient temperature prior to use. Handle in accordance with good industrial practise; no special precautions required with product alone. PPE should be worn in accordance with guidelines set out on the MSDS/Safety Data Sheet.

Disposal

Contaminated product and/or rinse water should be disposed of in accordance with local regulations. For more information please refer to the Product MSDS.

Health and Safety

R.S. Tyre Mark Remover should not cause any health and safety issues, when used in accordance with the recommended instructions. R.S. Tyre Mark Remover can cause eye damage and appropriate PPE should be worn during application. For more information please refer to the Product MSDS.