Axalta ViterLac ACV Finish is a single pack, alkyd high gloss finish for spray application with very fast drying properties.

Axalta ViterLac ACV Finish is idea for use where a fast-drying gloss finish is required. Fast drying minimises dust contamination to give a durable high gloss finish.

For use as a finish coat over ViterPrime 035 and other alkyd primers. Axalta ViterLac ACV Finish is suitable for agricultural and earth moving equipment and general use. Available in a wide colour range and indefinitely overcoatable, Axalta ViterLac ACV Finish can be electrostatically sprayed with suitable modification.

Approvals/Certification - Please consult Axalta Coating Systems or Rawlins Paints Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for more information.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Product Specification
• Film Thickness Range And Coverage
• Drying Times
• Surface Preparation
• Mixing
• Thinner
• Application Conditions
• Application Methods
• Product Notes
• Health & Safety

Features & Benefits

• Single pack, alkyd high gloss finish
• Very fast drying properties
• Fast drying minimises dust contamination to give a durable high gloss finish
• For use as a finish coat over ViterPrime 035 and other alkyd primers
• Suitable for agricultural and earth moving equipment and general use
• Can be electrostatically sprayed with suitable modification
• Available in a wide colour range and indefinitely overcoatable

Product Specification

Film Thickness Range And Coverage

Drying Times

Surface Preparation

• This product is a finish coat and should be applied over an appropriate primer and/or intermediate coat
• All surfaces to be coated should be dry and cleaned as necessary to remove all oil, grease, salts, weld flux or other contamination

Mixing

• Must be mixed thoroughly by using a mechanical agitator before use
• Agitate periodically to ensure paint remains homogeneous

Thinner

Thinner

• Axalta 1006 Thinner

Equipment Cleaner

• Axalta 1006 Thinner

Application Conditions

• Only apply in conditions of good ventilation which must be maintained during drying and curing
• Do not apply when rain, mist, sleet or snow are imminent
• During application and drying time of the paint coating, the surface should be dry, the relative humidity should not exceed 85% and the steel temperature should remain at least 3°C above the dew point
• Paint temperature should ideally be at a minimum of 15ºC

Application Methods

• Airless Spray: Output fluid pressure at tip 2000 psi min., Tip Size 11-13 thou (0.28-0.33 mm)
• Conventional spray: Typical air atomising pressure 40-60 psi. Will require thinning to 25-35 seconds @ 25ºC through a BS B4 Flow Cup
• Application by brush is recommended for touch up only as product is very fast drying. For brush application, ViterLac ABV is recommended
• Dependent on temperature, the material may require thinning up to 10% with 1006 Thinner

Product Notes

• Overcoating - this product goes through an intermediate period where wrinkling by subsequent application may occur. Overcoat before the lowest time shown, or leave until after the highest time shown, in order to allow adequate through drying
• Do not apply over white spirit based products. The compatibility of overcoating products should be confirmed prior to application
• Some shades may contain lead based colourants, and these are labelled (L)
• Not recommended for immersion
• For best opacity use a primer or undercoat of a suitable shade

Health & Safety

• Containers are provided with safety labels which should be observed
• Further information about hazardous influences and protection are detailed in individual Product Safety Data Sheets

For specific advice regarding any aspect of this product, please consult our Technical Department on 0113 2455450 (option 2) or send a message to [email protected]