Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application Notes
• Limitations

Features & Benefits

• Hard wearing - durable, low maintenance costs
• Three component system consisting of a Nitoflor FC150 base, hardener and colour pot
• High resistance to a wide range of industrial chemicals
• Hygienic - impervious finish provides easily cleaned surface
• Solvent free - no odour during application
• Attractive - available in a range of colours to improve the working environment
• A slip resistant finish can be obtained by use of one of the range of Nitoflor Antislip Grains
• Applied by trowel, squeegee and roller
• Compliance: Tested according to BS EN 13813:2002
• Chemical resistance tests have been conducted according to EN1504 standards (Class I)
• Suitable for use on Concrete (new and old)
• Nitoflor FC150 is non-flammable
• Other colours are available on request. Please contact us on 0113 2455450 (option 1) or send a message to [email protected] for details
• Please refer to the Product Data Sheet for full details of:
  • Properties
  • Standards Compliance
  • Chemical Properties
  • Application Instructions
  • Cleaning
  • Estimation
  • Storage
  • Precautions

Application Notes

• All coating work to be carried out in accordance with the relevant sections of BS 6150:2006, Painting of Buildings - Code of Practice
• New concrete floors: Unless specially water-reduced, the floor should be at least 28 days old and have a moisture content of less than 5%. Where these conditions are not met it may be possible to use Fosroc Nitoflor DPM as a primer
• Priming is not normally required provided the concrete substrate is sound, untreated, good quality and non-porous
• If the concrete is porous it should be primed with Fosroc Nitoprime 25. Contact our Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for details
• Two coats are recommended (See data Sheet)

Please see the Product Data Sheet for detailed information.

Limitations

• Nitoflor coatings should not be applied onto surfaces known to or are likely to suffer from rising damp, potential osmosis problems or have a relative humidity greater than 75% as measured in accordance with BS 8203 Appendix A or by a Vaisala thermohygrometer type HMI 31
• Fosroc does not recommend acid etching as a method of floor preparation. If used, the method should be approved by the project consultant
• In common with all epoxy materials, some slight shade changes may be experienced over the long term when placed in adverse exposure conditions. Any such change in shade is not regarded as being detrimental to performance
• The manufacture of Nitoflor FC150 is a batch process and despite close manufacturing tolerances variation may occur between batches. Fosroc recommends using material from one batch only as the finish topcoat

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.