Follow us on:

Watco Basics Floor Repair Mortar | Tough Repairs for Concrete
Watco Basics Floor Repair Mortar | Tough Repairs for Concrete

Watco Basics Floor Repair Mortar

WB-01258
WAT9323

Watco Basics Floor Repair Mortar can be used to fill holes in concrete inside and out. It is strong enough to resist heavy foot traffic, trolleys and trucks. Just take as much powder as you need out of the bucket, mix with water and trowel into place – you don’t need a primer.

  • Easy mix polymer and cement formulation
  • Heavy traffic after only 4 hours
  • Non dusting, resists grease and oil
  • Repairs from 5mm to 100mm thick in one go

For areas where there is regular forklift traffic, see Watco Flowpatch.

Minimum repair thickness is 5mm. Not recommended for ‘feather edge’ repairs (see Watco Concrex).

Size
£58.50(incl. VAT)
£48.75(ex. VAT)
Quantity
Please choose your colour
Available for Delivery (See Delivery Options Below)

No queries yet, leave the first!
Description

Watco Basics Floor Repair Mortar can be used to fill holes in concrete inside and out. It is strong enough to resist heavy foot traffic, trolleys and trucks; (for areas where there is regular forklift traffic, see Watco Concrex). Just take as much powder as you need out of the bucket, mix with water and trowel into place – you don’t need a primer.

The mortar will not shrink as it dries and will take full traffic after only 4 hours.



Quick Links - Click To Jump To Section:




Features & Benefits


  • Areas of use:
    • Damaged floors, ramps and steps
    • Indoors & outdoors
  • Easy mix polymer and cement formulation
  • Heavy traffic after only 4 hours
  • Non dusting, resists grease and oil
  • Repairs from 5mm to 100mm thick in one go



Preparation


Only basic preparation is necessary. If the hole or patch to be repaired is just dirty and dusty, give it a good sweep. Watco Basics Floor Cleaner can be used to remove oil and grease, or grease and loose material can be removed from small patches using a stiff broom or wire brush.



Application


  • It does not matter if the floor has been left damp following any wet preparation
  • Dampen dusty, porous surfaces with water in hot, dry conditions
  • The mortar can be applied at any thickness between 5mm and 100mm. For deeper holes build up in layers, allowing the first layer of 100mm to dry for 12 hours
  • If the edge of the repair is less than 5mm deep, chip some concrete away so that the edge of the mortar repair will be 5mm thick. For feather edge repairs which go to nothing please see Watco Concrex
  • Remove the bag of powder from the Floor Repair Mortar bucket
  • The mix is 1 part water to 7 parts powder by volume, or 10 parts powder to 1 part water by weight
  • Only mix as much as you can use in 5 - 10 minutes. A cup can be used to measure the parts of water and powder
  • Put the water into the plastic bucket
  • Gradually add the powder mixing continuously. We recommend a mixing blade fitted into an electric drill. The ratio of water to powder is not critical, you just want the mix to be a consistency which can be poured. If it looks too runny add more powder, or too stiff, more water
  • Once you’ve stopped mixing and started using the product do not re-mix it
  • Immediately place the mortar into the repair and trowel firmly into place. Wipe the trowel with a wet cloth to help get a smoother finish



Limitations


  • Minimum repair thickness is 5mm. Not recommended for ‘feather edge’ repairs (see Watco Concrex)
  • Resists oils and grease but not chemicals (see Watco Concrex)
  • Do not use at temperatures below 5°C. Watco Flowpatch Sub Zero is for cold weather repairs
  • It can be applied up to 100mm. For deeper holes build up in layers, allowing the first layer of 100mm to dry for 12 hours



Product Details
9323-947153

Data sheet

Manufacturer
Watco
For Use By
Consumer Use
For Use On
Concrete
Application Method
Trowel
Single, Two or Three Pack
Single
Pack Size
10KG
Maximum Applied Thickness
100mm. For deeper holes build up in layers, allowing the first layer of 100mm to dry for 12 hours.
Coverage
A 10kg unit will produce approximately 5L of mortar which covers 1m2 at 5mm thick.
Min. Application Temperature
5°C
Shelf Life (from date of manufacture)
12 months in unopened containers.
Resistance to chemicals
Grease
Resistance to chemicals
Oil
Drying time
Walk on: 2 hours
Trucks & trolleys: 4 hours
Suitable For Use On
Concrete
Suitable For Use On
Floors
Suitable For Use On
Concrete Floors
Application Method
Trowel
Product Usage Type
Repair
Product Range
Watco Basics
Product Range
Basics
Attachments
Download


Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product. Where we have access to the Product Data Sheet from the manufacturer, we will either provide a copy on request, or include a link to the Product Data Sheet available on the manufacturer’s website. Customer further agrees that we have no liability for any errors or omissions contained within the Product Data Sheets. For more information, please see our Terms & Conditions of Sale.

Questions

Question about the product

* Required fields
(read)

Be the first to ask a question about this product!

IMPORTANT SHIPPING & DELIVERY INFORMATION

Watco Basics Floor Repair Mortar is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.

Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.

Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.

All delivery costs below are excluding VAT


You might also like