Please consult our Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for specific advice.

Slip Resistance

Should a non-slip finish be required, 508 Fine Particle Anti-Slip Additive can be added to the coating during mixing prior to application to produce an even and easily cleanable texture to the dried surface.

Alternatively the 'Anti Slip' option can be selected when purchasing the product and the 250 micron grade of 508 Anti-Slip Additive will be added at 2.4% prior to receipt.

• 5kg unit - add 200g
  
• 15kg unit - add 600g

The above recommendation must only be used as a general guideline as the slip resistance of a cured resin coating can vary considerably due to many factors including: application technique, variations in film thickness, dispersion of the anti-slip texturing additive and the surface variations of the substrate and location to where it will be applied.

To obtain accurate PTV readings that are site specific (if required) it is strongly recommended that a slip assessment pendulum test is undertaken on each specific site after completion of the installation when the resin has fully cured.

Coverage

• A 5kg pack is sufficient to seal 16 - 33m² of surface per coat

Surface Preparation

• All surfaces should be sound, clean, and free from dust, dirt, laitance, oil and other contaminants
• All laitance must be removed by vacuum grit blasting, ensuring that any residual dust is removed prior to coating application
• New concrete surfaces must be a minimum of 21 days old and/or have a residual moisture content below 6%
• For sealing flaked SL screeds, ensure that the screed surface has been thoroughly ‘de-nibbed’ and is free from contaminants

Mixing:

• Pour the contents of the curing agent container into the base container and thoroughly mix, preferably by mechanical means until a uniform consistency is achieved
• The mixed material may be thinned by the addition of up to a maximum of 10% by volume of clean, potable water

Mixing Ratio:

• By Weight = 100 Base : 52.4 Curing Agent

Application

• Apply by brush, or roller to the prepared surface at a nominal rate of 0.15-0.30kg/m²
• Should a second coat be required, allow the first coat to cure for a minimum period of 14 hours @ 20°C

Cleaning

• Clean equipment with 109 Tool Cleaner prior to curing of the coating

Curing

• Should a second coat be required, allow the first coat to cure for a minimum period of 14 hours @ 20°C
• 7 days cure @ 20°C is recommended prior to exposure to chemicals

Limitations

• Do not apply to wet or uncured concrete surfaces
• Do not apply at temperatures of 3°C or less

Storage & Shelf Life

• Store in dry conditions, out of direct sunlight, at temperatures between 10°C and 25°C
• Do not expose to freezing conditions
• 305 HD Clear Sealer has a minimum shelf life of 12 months when stored in original, unopened containers in accordance with manufacturer’s instructions

Health & Safety

• Avoid contact of the material with skin and eyes
• Wear gloves and goggles
• Wash off splashes immediately with soap and water
• Any eye contamination must be rapidly irrigated with copious amounts of water, and immediate medical attention sought
• Please refer to Material Safety Data Sheet for additional Information
• 305 HD Clear Sealer shall be applied strictly in accordance with the manufacturer’s instructions

For specific advice regarding any aspect of this product, please consult our Technical Department on 0113 2455450 (option 2) or send a message to [email protected]