Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Performance
• Installation

Features & Benefits

• Suitable for multiple substrates including:
  • Solid walls and floors; flexible walls
  • Multi-service penetrations
  • Head of wall
  • Blank seals
  • Face-fixed applications
  • Large-framed service voids
• Can provide fire resistance from a single thickness batt
• Comprehensively tested as part of the Firepro suite of solutions
• Suitable for sealing wall and floor voids containing most commonly used services and substrates
• Can be used as a blank seal and a head of wall seal
• Lightweight and simple to install
• Tested for air tightness, providing an additional smoke and acoustic seal

Performance

• Tests have proved the capability of a single 50mm Batt to provide up to 2 hours* fire resistance Integrity and Insulation ratings which are dependent upon the service penetrations and void size
• Where 4 hours integrity and insulation are required we recommend the use of our 60mm Ablative Coated Batt
• Certified by UL and CE marked to EAD 350454-00-1104

*Subject to application

Tested for head of wall:

• Rw= up to 48db (2 x Coated batts)
• Rw= up to 37db (1 x Coated batts)

The correct use of Coated batt within concealed cavities and voids will reduce the level of transmitted sound:

• Rw= up to 52 db (2 x Coated batts) - incorporating 48mm O/D PVC /15mm copper pipe penetrations
• Rw= up to 34 db (1x Coated batts) - incorporating 48mm O/D PVC /15mm copper pipe penetrations

Installation

• Please see Product Data Sheet and Installation Guide for detailed installation instructions.
• Make sure that the area within the aperture is clean of any debris and remove any dust from the edges
• Cut the batt to the size and shape required to fit the aperture ensuring that batt will make a tight fit with all edges of the aperture
• Cut rectangular holes from the coated batt to accommodate cable trays or ladders containing cables
• Cut the Coated Batt across its width at the mid-point of each rectangular hole to enable the Batt to be fitted into the aperture
• Apply Rockwool Acoustic Intumescent Sealant to all edges of the Batt ensuring that an even cover is achieved over the entire thickness of the Batt. This should include the outer edges of the Batt and the edges of the cuts made across the Batt to allow fitting into the aperture
• Insert the Batt into the aperture
• Apply a bead of Rockwool Acoustic Intumescent Sealant approximately 15mm wide around the perimeter of the Batt ensuring that all gaps between the Batt and surrounding edges are fully filled
• Apply a bead of sealant approximately 15mm wide where cables pass through the Batt. Ensure that the sealant fully enclosed each cable within the tray or ladder and that all gaps are fully filled
• Repeat step 7 and 8 on the other side of the Batt
• Not intended for use as load-bearing seals
• Where a loadbearing seal is required, Rockwool Firestop Compound should be considered

IMPORTANT FIRE PRODUCTS NOTICE: The information displayed on this website should be used as a guide ONLY and our Technical Department should be contacted to obtain a tailored specification and any advice necessary before you place an order for fire protection products. Fire protection products are non-returnable except in accordance with Condition 8 of the Terms and Conditions and should be applied only by an individual with the necessary expertise and experience. We will not be held liable for any resulting damage to property, human life or monetary costs incurred due to the incorrect specification you have prepared or use of fire protection products caused by your negligence, including your failure to have contacted us to obtain the relevant advice/specification.