It is also an ideal solution for anchoring close to edges or when there is a limited pitch between each anchor, due to no stress being generated as with conventional mechanical expansion fasteners.

Mapefix PE SF is recommended for anchoring lightweight elements in internal and external substrates with a horizontal, vertical, inclined or overhead axis, and is particularly recommended for anchors in perforated substrates. It may also be used for anchors in damp substrate, and in substrates at temperatures down to -5°C.

Does not contain styrene which makes it suitable for use in areas with poor ventilation and, because it has limited shrinkage, it is also suitable for anchors with small circular crests.

Quick Links - Click To Jump To Section:

• Features & Benefits
• Recommendations & Limitations
• Application & Preparation

Features & Benefits

• Two-component chemical anchoring product, packaged in 300 and 420 ml cartridges with two separate compartments containing component A (resin) and component B (catalyser), at the correct mixing ratio in volume
• The two components are mixed together when they are extruded via the static mixer supplied with the cartridge
• The mixer is screwed to the end of the cartridge, and no preliminary mixing of the two components is required. If only part of the cartridge is used, the remaining product may be used, even after a number of days by replacing the original static mixer with a clean, new one
• Does not contain styrene which makes it suitable for use in areas with poor ventilation and, because it has limited shrinkage, it is also suitable for anchors with small circular crests
• A chemical anchor made from a mixture of styrene-free resins, suitable for application on solid and perforated building materials, such as:
• Non-cracked concrete
• Lightweight concrete
• Cellular concrete
• Masonry
• Bricks
• Stone
• Applied in holes made with a drill or hammer drill. Mapei recommend using only a drill on perforated substrates
• Certified according to ETA European Standards option 7 (anchors in concrete in tension zones) and ETAG 029 (anchors in solid, semi-solid and perforated masonry)
• 300 ml size cartridges may be used with conventional silicone extrusion guns for 50 mm diameter cartridges, as long as they are robust enough. The 420 ml cartridges need to be used with a special extrusion gun for 65mm diameter cartridges

Recommendations & Limitations

• Do not apply on dusty or crumbling surfaces
• For use on damp or wet substrates, please contact Mapei or Rawlins Technical department on 0113 2455450 (option 2) or send a message to [email protected]
• Do not use on surfaces with traces of oil, grease and stripping compound otherwise the bond may be compromised
• Do not apply if the temperature is lower than -5°C
• If used on natural stone, check if it impregnates into the stone
• Do not apply loads until it has completely hardened
• Do not use the product in holes made with a diamond-tipped bit (cored holes)
• Do not use for anchors in tension zones

Application & Preparation

Please refer to the data sheets in the tab above for further information.