Quick Links - Click To Jump To Section:

   
• Features & Benefits
• Application Notes
• Limitations

Features & Benefits

• Fast development of strength minimises disruption — stronger than concrete within 2 hours
• No primer required
• High chemical and oil resistance — unaffected by water, petrol, oil and many corrosive chemicals when fully cured
• Extremely versatile — can be poured, trowelled or modified with aggregate without significantly affecting setting times or strengths
• Extremely low wastage due to ability to mix part packs to consistencies required
• Will cure down to 0°C
• Will cure under water. Consult our technical team at 0113 2455450 (option 2) or send a message to [email protected] when considering underwater application
• Pre-weighed components ensure consistency 
• Formulated to reduce shrinkage to a minimum. Linear shrinkage will be approximately 0.8%. No further shrinkage will occur after the material has cured
• Performs under temperatures as high as 60°C and down to sub-zero conditions when fully cured
• Please refer to the Product Data Sheet for full details of:
  • Properties
  • Specification Clause
  • Standards Compliance
  • Product Installation
  • Estimating
  • Storage
  • Health and Safety
  • Design Criteria
  • Compressive strength gain
  • Mix Design

Uses

• For fast and emergency reinstatement of concrete, bedding, jointing and reprofiling of concrete, masonry and brickwork
• Ideally suited for the repair and reprofiling of precast concrete units, damaged arrises and treads
• can be used to infill hollows and holes in concrete floors, bedding and fixing kerbstones, manhole sets, frames, brick slips, ceramic tiles, slabs and coping stones
• Especially useful where fast strength gain is important
• Highly impermeable when properly impacted
• Nitomortar PE Concrete should be used to repair larger voids

Application Notes

• Supplied as two-component products with pre-weighed quantities of liquid resin and powdered hardener, ready for on-site mixing and use
• The hardener system enables the mix to be varied from a pourable consistency to a trowellable mortar without significantly affecting the setting times or strengths achieved
• Can be applied in cold conditions down to 0°C. Winter Grade is recommended for cold conditions
• At ambient temperatures above 25°C, Nitomortar PE will have shorter pot lives and working lives. The material should not be used at ambient or surface temperatures above 35°C
• Exposed steel reinforcement should be treated with one full coat of Nitoprime Zincrich Plus. This should be allowed to dry before continuing
• No priming or curing protection is necessary when using Nitomortar PE products
• When larger areas are being rendered (generally over 0.25m²) a chequerboard application technique is recommended
• The application of additional layers should follow between 8 and 24 hours after the first application
• Finish with the use of a steel trowel which may be wiped from time to time with a cloth moistened with Fosroc Solvent 105
• Should be removed from tools, equipment and mixers with Fosroc Solvent 105 immediately after use
• Yield: 7.5 litres / 14 kg pack

Limitations

• Should not be applied to damp or wet surfaces where there is total reliance on bond nor should they be exposed to moving water during application
• Exposure to heavy rainfall prior to the final set may result in surface scour
• Nitomortar PE products are flammable. Keep away from sources of ignition. No Smoking. In the event of fire, extinguish with CO2 or foam. Do not use a water jet