- There are no more items in your cart
- Shipping Calculated at checkout
-
Sub-Total (inc. VAT)
£0.00
Ultimate all surface paint with up to 15 years performance, available in Anthracite Grey and recommended for use on masonry, uPVC and composite windows and doors.
- Looking for a lighter or darker grey? Also available in 3,900+ colours
- Also suitable for masonry, timber, metal, plastic, concrete, cladding, weathered bitumen, stucco, brick, stone and more
- Read our blog post on painting uPVC, or click here for FAQ's about painting uPVC
- Cracking, blistering, flaking and weather resistant
- Anti-fungal degradation - Bonds to glossy paint - Re-coatable in 1 hour
- Where application conditions (i.e. winter months) do not allow for water based paint to be used externally, it is recommended to use Zinsser Allcoat Exterior Solvent Based instead
- Not suitable for application on floors
- Please note: Matt finish products can be more susceptible to scuffs, watermarks, dirt, etc. in areas of frequent contact/use such as windows, doors, roller shutters etc. an alternative finish may be more suited (Satin & Gloss). Please contact our Technical Department on 0113 2455450 (option 2) or send a message to [email protected] for further advice if in doubt
Please always refer to the downloadable PDF`s from the "Data Sheets" tab for more information on:
- Technical Data
- Suitable Surfaces and Substrates
- Substrate Preparation
- Application Instructions
- Suitable Primers/Topcoats (where applicable)
- Drying Times
- Application Equipment
- Health & Safety Information
- Warranty
Data sheet
- Manufacturer
- Zinsser
- For Use By
- Consumer Use
- For Use On
- Wood, uPVC, Galvanising, Metal, Cladding, Bitumen, Stucco, Brickwork, Stone, Concrete, Glossed Surfaces
- Sheen
- Matt
- Colour
- Anthracite Grey
- VOC Levels
- Ultra-Low (5-49 g/l)
- Single, Two or Three Pack
- Single
- Pack Size
- 1L, 2.5L, 5L, 10L
- Application
- Brush, Roller, Spray
- Dry to Recoat (at 20°C)
- 1 Hour
- Fully Cured (at 20°C)
- 7 Days
- Coverage
- 12m² per litre
- Min. Application Temperature
- 10°C
- Density
- 1.25 kg/litre
- Solids by Volume
- 40%
- VOC
- 35g/l
- Shelf Life (Once Opened)
- 2 years in unopened containers
- Touch Dry
- 30 mins
- Recommended Dry Film Thickness
- 40 microns
- Hard Dry
- 4 Hours
- Colour(s)
- Standard Colours
- Colour(s)
- Fully Tintable
- Base Type
- Water-Based
- Suitable For Use On
- Stone
- Suitable For Use On
- Glossed Surfaces
- Suitable For Use On
- Walls
- Suitable For Use On
- Doors
- Suitable For Use On
- Trim Skirting
- Suitable For Use On
- Windows
- Suitable For Use On
- UPVC
- Suitable For Use On
- Front Doors
- Suitable For Use On
- Masonry
- Suitable For Use On
- Garage Doors
- Suitable For Use On
- Timber
- Suitable For Use On
- Metal
- Suitable For Use On
- Cladding
- Suitable For Use On
- Weathered Bitumen
- Suitable For Use On
- Concrete
- Suitable For Use On
- Plastic
- Suitable For Use On
- Stucco
- Suitable For Use On
- Brick
- Finish
- Matt
- Application Method
- Brush
- Application Method
- Roller
- Application Method
- Spray
- Manufacturer
- Zinsser
- Fastest Delivery
- Next Working Day
- Colour Family
- Anthracite Grey
Questions
Question about the product
Kate on 2024-07-29 14:23:59 | Question:
Can this be used for wooden cladding also? We have a house which is a mixture of rendering and wooden cladding and are looking for a paint which can be applied to both. |
Answer from Rawlins’ Technical Team:
Assuming the wooden cladding is previously painted, is clean, dry, sound and lightly abraded prior to application, this product can be applied to this type of substrate. 2 coats to achieve the intended finish, we'd recommend to apply to a small test area firstly to check for compatibility and adhesion prior to full application. | |
Laura on 2021-10-28 20:44:13 | Question:
Do you need to use a primer under this paint ? |
Answer from Rawlins’ Technical Team:
This will depend on what substrate is to be painted, if the substrate is previously painted we would recommed testing for compatibiliry and adhesion prior to full application without a primer. Timber should be primed with Zinsser Cover Stain and for uPVC this can be applied directly once the substrate has been prepared. | |
IMPORTANT SHIPPING & DELIVERY INFORMATION
Zinsser AllCoat Exterior Anthracite Grey - Matt (Water Based) is only available with the shipping and delivery timescales listed below - please do not contact our Customer Support Team with enquiries about alternative or earlier shipping and delivery times.
Saturdays and Sundays, as well as Bank Holidays, are not classed as working days.
Orders placed after the cut-off for this product will not be processed for earliest dispatch until 9am the next working day.
All delivery costs below are excluding VAT
Zinsser Bulls Eye 1-2-3 Plus
White stain blocker. For interior and exterior walls, ceilings, doors, trim, fascia, soffits, foundations, railings, and related paintable surfaces. Bonds to glossy surfaces without scuff sanding. Formulated with proprietary stain-blocking resins. Binds moderately chalky surfaces. Dries quickly, touch dry in 30 minutes, and can be...
Zinsser B-I-N Aerosol
White matt. For interior ceilings, walls, doors, trim, cabinets, furniture, and related paintable surfaces. Dries in minutes; can be recoated in 45 minutes. Superior adhesion to glossy surfaces without scuff sanding. High-hiding formula blocks stubborn and persistent stains. Permanently blocks odours and seals bleeding knots and sap...
Zinsser Bulls Eye 1-2-3
Available in 3,000 colours. Usable on interior and exterior surfaces: walls, ceilings, doors, trim, fascia, soffits, foundations, railings, and more. Adheres to glossy surfaces without pre-sanding. Resists mould and mildew growth. Fast drying - recoat in 1 hour. Compatible with both oil and latex topcoats. Buy A Paint Colour...
Zinsser Cover Stain
High-performance, solvent-based primer-sealer in 2,900+ colours. Suitable for both interior and exterior surfaces including wood, plaster, metal, masonry, and more. Fast Drying: Recoat in less than 2 hours. High Hiding Formula: Blocks tough stains such as water, fire, smoke, and nicotine. Excellent Adhesion: Sticks to all surfaces...
Zinsser B-I-N
Shellac-based primer-sealer and stain killer in 1,500+ colours. For interior and spot exterior applications on ceilings, walls, doors, trim, cabinets, furniture, and more. Quick Drying: Dries to the touch in 20 minutes and can be recoated in 45 minutes. Superior Adhesion: Adheres to glossy surfaces without the need for sanding. Stain...
Zinsser Cover Stain Aerosol
Primer-sealer stain killer aerosol available in white. Can be used on interior and exterior surfaces, including ceilings, walls, doors, trim, cabinets, and more. Fast drying, can be recoated in less than 2 hours. Blocks most stains, including nicotine and water-soluble tannin bleed. Suitable for use on fire, smoke, and water-damaged...
General Painting Application Kit
Provides the basics for any painting project. Whether it is a one off job, or you just want to make sure the right application tools get to site. Provides an economical way of making sure you will have what you need Ideal for interior and exterior paint projects, including uPVC surfaces, walls, ceilings, and more. Click to jump down to...
Zinsser Universal Degreaser & Cleaner
Water-based detergent. It can be used on tiles, grout, baths, sinks, showers, tools, equipment, machinery, driveways, BBQs, and ovens. Removes tough stains such as grease, oil, paint overspray, adhesive, wax, food stains, and more. Ideal for cleaning surfaces before painting, ensuring a smooth, residue-free finish. Suitable for both...
Zinsser Mould Killer & Remover
Effective mould, fungus, and algae remover. Ideal for use on internal surfaces such as tiles, wood, plaster, and wallpaper. Perfect for bathrooms, kitchens, and high-humidity areas. Contains a powerful fungicide for a better and longer-lasting paint finish. Fast-acting formula that cleans and prepares surfaces for painting. Suitable for...